Subcutaneous injection: generally used for the prevention of drugs, such as vaccines and drug injections, the more standard injection site is the rabbit's neck behind the ear, more relaxed between the subcutaneous and muscle, because the prophylactic drugs or vaccines are long Effective, and some to achieve the effect of prevention for more than six months, and injections in the skin, often form a small packet, the greater the injection dose, the greater the formation of the packet, this is a normal symptom (often people Ask me this question, special note). Because the drug does not enter the blood circulation, it only releases the drug slowly under the skin, so it can achieve long-term prevention. The first injection should be disinfected with iodine, then the left hand to grasp the rabbit ears, leaving the thumb and index finger separate the surface of the hair, lift the neck skin, so that the skin was triangular, the injection needle from the head to the tail slightly oblique insertion of triangular skin In the neutral gear, it feels as if it is a layer of thick paper, and then it advances the injection and it is finished. Intramuscular injection: Most of them are used for therapeutic injections. Generally, they are injected at the site where the muscles are full. Such as the inner thigh, buttocks, neck, but the novice recommended direct injection of the hips, injections easier to grasp. At the time of injection, if you encounter a rabbit that is thin and has less muscle, you can bend the rabbit's leg and naturally bulge the muscles, which makes injection easier. One person can use the Baoding method to fix the injection. (It's more troublesome to use a Baoding method. The simplest method is to wrap the rabbit in the old clothes like a tweezers, so that it can't struggle at all, and then open the clothes that need the injection site. So that it can be easily injected). You can also take your own legs and place your rabbit's head in your legs. Then, split the hair and sterilize it. This is also very convenient. As for skin disinfection, disinfection of syringes, pumping drugs, discharge of air, etc. It is particularly worth noting that the general therapeutic drugs are not specifically required for skin or intravenous injection, and it is best to use intramuscular injection. The effect is quick and thorough. Intraperitoneal injection: Generally used for the treatment of rabbit enteritis, rabbit intra-abdominal adhesions, mucinous enteritis, dehydration and other diseases. The method of injection is to hold the rabbit's body on both legs and make it unable to move. The injection site is mainly selected on the front edge of the rabbit pubic bone and on both sides of the ventral midline. Before the injection, the rabbit hair is cut off or separated by hand to completely disinfect the skin. Pull out the liquid, and then hand over the rabbit again, so that the rabbit viscera drooping down to the chest, the abdomen naturally empty and outward, with the legs to hold the rabbit body. Use your left hand to pinch the abdominal skin of the rabbit. After about 1 to 1.3 cm of the needle, push the injection solution. It feels more relaxed when the needle is inserted, and there is no resistance which means that it is inserted into the abdominal cavity. In the case of intraperitoneal injection, it is relatively easy to select before feeding the feed, or to pull urine and defecate, and the injection is accurate. Intravenous injection: mainly used for the treatment of rabbit cyanide poisoning, the outer edge of the rabbit ears covering the veins of the skin unplugged or cut off, but also wet parts with water, make the hair clot, easy to separate, and then gently rub the rabbit ears Or use a finger to play a few blood vessels, so that the rabbit's ear blood flow increased significantly, and in the ear root will be pressed to the ear vein, so that its blood vessels bulge. Finally, with the left index finger and the middle finger slightly clamped the end of the vein proximal to the right, holding the syringe to the right obliquely with the venous blood vessels at an angle of about 30 degrees, from the end of the vein gently oblique into about 1 ~ 1.3cm. If you feel that the resistance of the needle is large during injection, or if local swelling occurs, it means that the needle has not accurately entered the vein. You should immediately remove the needle and reposition it. If the injection does not feel resistance, then the liquid can be gently injected. After the liquid is injected, the needle is withdrawn, and then the injection site is pressed with a cotton wool to help stop the bleeding. Sodium Erythorbate,Sodium Erythorbate Powder,Food Additives Sodium Erythorbate,Antioxidant Sodium Erythorbate SHANDONG BAISHENG BIOTECHNOLOGY COM , https://www.baishengbioproducts.com
Several commonly used injection methods for treating or preventing rabbits
During this period of time, in many rabbit-raising groups, many new friends who have just been involved in raising rabbits are often asked how to inject rabbits. It is appropriate or correct to inject rabbits. In fact, most people listen to others once and they will At most, it is more than a few attempts to OK. However, some of them still do not understand N times, or are afraid to get it wrong. They can't grasp the depth of the drills. They have problems or even die. These friends are basically not having a basic concept about injections, and they dare not experiment. In fact, it is almost the same as when people are injected. I have a habit of this person. When I see other people in rabbit breeding groups discussing rabbit raising issues, there are different opinions, or when he feels that he may mislead new people, or when several people ask me the same question in succession, It will write an article because it avoids the problem of repeating N times and allows the novice to see more detail and understanding.